|
|
| Line 413: |
Line 413: |
| | ===Various commercial rust treatment products=== | | ===Various commercial rust treatment products=== |
| | | | |
| − | ====Rust converters/dissolvers====
| + | |
| − | *[http://www.tinmantech.com/html/must_for_rust_remover_inhibi.php Must for Rust] Merchant description: removes rust and corrosion, non-caustic to skin, needs no neutralizing, primer goes right over it. $28/gallon.
| + | |
| − | *[http://www.eastwoodco.com/shopping/product/detailmain.jsp?itemID=15974&itemType=PRODUCT&iMainCat=373&iSubCat=374&iProductID=15974 Eastwood Rust Converter] Merchant description: 2-part mix, adheres to bare or rusty steel, and can be topcoated with most coatings. 1 gallon each of the 2-part mix is $125.
| + | |
| − | *[http://www.rust-cure.com/ Rust Cure] Merchant description: phosphoric acid-based. leaves a thin film that bonds well with most primers and paints. for pricing, need to see this page: http://rustcure.bizland.com/xwheretobuy.html .
| + | |
| − | *[http://www.eastwoodco.com/jump.jsp?itemID=1124&itemType=PRODUCT Oxisolv Rust Remover] Merchant description: dissolves rust and leaves behind a zinc phosphate coating. Spray/brush/dip. Non-toxic, non-flammable, and re-usable. Must be cleaned off before priming.
| + | |
| − | *[http://www.eastwoodco.com/jump.jsp?itemID=11122&itemType=PRODUCT Eastwood Rust Dissolver] Merchant description: acid free rust remover, leaves surface ready to paint, plate, or powder coat. Suitable for engine parts, and harmless to copper, brass, aluminum, solder, lead, plastic, rubber, seals, wood or vinyl. Surface must remain wet for product to work. $40/gallon.
| + | |
| − | *[http://sem.ws/product.php?product_id=164 Rust-Mort] Merchant's description: "Converts rust to a black or grayish, hard, insoluble, protective coating".
| + | |
| − | *[http://sem.ws/product.php?product_id=206 SEM Rust-Seal] Manufac descrip: "Transforms rust leaving a tough, permanent, black protective coating. RUST-SEAL can be left exposed or may be topcoated with enamels, lacquers or urethanes."
| + | |
| − | (What about the converters that leave a "protective film" on the metal. They say that they don't need neutralization, and they don't need to be washed off. Is this as good as cleaning to bare metal, and then hitting with epoxy primer?)
| + | |
| | | | |
| | ====Rust encapsulators==== | | ====Rust encapsulators==== |
Your Privacy Choices