Make a fiberglass fan shroud
(→Constructing the foam buck) |
|||
| Line 1: | Line 1: | ||
| − | This in-progress article | + | This in-progress article will demonstrate one way to build a fiberglass fan shroud. The techniques used in this article can be applied to just about any part that can be constructed from fiberglass. |
===Measurement and analysis=== | ===Measurement and analysis=== | ||
| Line 46: | Line 46: | ||
| + | ===Forming the circular part of the shroud=== | ||
I knew that one part of the shroud was going to be perfectly round, so I set it up with a bolt in the center and made it so it could be spun by hand against an end mill. This will make it easy to shape the circle, as well as cut the box section down to its proper thickness. | I knew that one part of the shroud was going to be perfectly round, so I set it up with a bolt in the center and made it so it could be spun by hand against an end mill. This will make it easy to shape the circle, as well as cut the box section down to its proper thickness. | ||
Your Privacy Choices