Bondo
From Crankshaft Coalition Wiki
(→DIY body filler recipes) |
(→Body filler tips) |
||
| Line 8: | Line 8: | ||
*[http://solutions.3m.com/wps/portal/3M/en_US/3MAutomotive/Aftermarket/Products/Product-Catalog/?PC_7_RJH9U5230GE3E02LECFTDQCEK3_nid=02PKX0XCK6beFDKXQL309Jgl 3M body fillers and auto body repair products] | *[http://solutions.3m.com/wps/portal/3M/en_US/3MAutomotive/Aftermarket/Products/Product-Catalog/?PC_7_RJH9U5230GE3E02LECFTDQCEK3_nid=02PKX0XCK6beFDKXQL309Jgl 3M body fillers and auto body repair products] | ||
*[http://www.evercoat.com/products.aspx Evercoat] | *[http://www.evercoat.com/products.aspx Evercoat] | ||
| + | *[http://solutions.3m.com/wps/portal/3M/en_US/3MAutomotive/Aftermarket/Products/Product-Catalog/?PC_7_RJH9U5230GE3E02LECFTDQCEK3_nid=MD5SPM1WHRgsFDKXQL309JglF3N1FCNSSKbl Marson Platinum Plus] | ||
=="Waterproof" body fillers== | =="Waterproof" body fillers== | ||
| Line 15: | Line 16: | ||
==Body filler tips== | ==Body filler tips== | ||
| + | In a large flat plastic if or disposable surface Make small batches of well folded body filler, apply small batches in wide thin layers. Sanding and cleaning once partially hardened. This will result in a better finish and smoother transitions. It will also reduce waste; saving money. | ||
*For body lines and peaks on hoods or doors, use a contour gauge to make a custom plastic filler spreader: | *For body lines and peaks on hoods or doors, use a contour gauge to make a custom plastic filler spreader: | ||
#Place the contour gauge on an undamaged area to get the contour. | #Place the contour gauge on an undamaged area to get the contour. | ||
| Line 30: | Line 32: | ||
*Use an aluminum ruler to find high and low spots such as doors, hood to fender, trunk lid to fender, etc. | *Use an aluminum ruler to find high and low spots such as doors, hood to fender, trunk lid to fender, etc. | ||
*If using filler with hatonite you can sand filler while still tacky. This will shred the filler smooth easily with hardly any pressure. When finished, follow up with a polyester glaze or add filler thinner to your final coat of filler. | *If using filler with hatonite you can sand filler while still tacky. This will shred the filler smooth easily with hardly any pressure. When finished, follow up with a polyester glaze or add filler thinner to your final coat of filler. | ||
| − | |||
==DIY body filler recipes== | ==DIY body filler recipes== | ||
Your Privacy Choices