Camshaft install tips and tricks

Jump to: navigation, search
(General cleanup for syntax, organization, and checking/adding links)
(Engine RPM for break in)
Line 71: Line 71:
 
'''11. Failure to clearance lifters in their bores so that they spin freely.'''
 
'''11. Failure to clearance lifters in their bores so that they spin freely.'''
  
Lifter clearance should be 0.0012" to 0.002", with 0.0015" (one and one/half thousandths) considered close to ideal. Too loose is as bad as too tight. One more way to "bulletproof" a flat tappet installation is to groove the lifter bores for oiling the cam lobes. See the first tool in this link: http://www.compcams.com/products/335-353.pdf ''(this link is not working; needs to be checked)''
+
Lifter clearance should be 0.0012" to 0.002", with 0.0015" (one and one/half thousandths) considered close to ideal. Too loose is as bad as too tight. One more way to "bulletproof" a flat tappet installation is to groove the lifter bores for oiling the cam lobes. Here is the CompCams tool offered by Summit.....
 +
http://www.summitracing.com/parts/CCA-5003/
  
  
Line 96: Line 97:
 
'''16. Failure to use new lifters on a used cam.'''
 
'''16. Failure to use new lifters on a used cam.'''
  
Used lifters should only be used on the very same cam, in the very same block, and in the very same positions they were removed from. Chances that the lifter bores will be machined on the very same angles on a different block as the block the lifters came out of are about equal to you hitting the lottery. If you purchase a used flat tappet cam from a swap meet or yard sale, plan on using it for a doorstop.  
+
Used lifters should only be used on the very same cam, in the very same block, and in the very same positions they were removed from. Chances that the lifter bores will be machined on the very same angles on a different block as the block the lifters came out of are about equal to you hitting the lottery. If you purchase a used flat tappet cam from a swap meet or yard sale, plan on using it for a doorstop.
  
 
==Miscellaneous==
 
==Miscellaneous==

Revision as of 02:46, 27 August 2010

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox