TH400 rebuild tech
m (clean up) |
m (→Center support assembly) |
||
| Line 241: | Line 241: | ||
Install the center support bolt finger tight, then install the beveled case ring with the gap at the 9 o'clock position. | Install the center support bolt finger tight, then install the beveled case ring with the gap at the 9 o'clock position. | ||
Then using a screwdriver through one of the feed holes in the VB area, force the center support in a counterclockwise direction and tighten the center support bolt. | Then using a screwdriver through one of the feed holes in the VB area, force the center support in a counterclockwise direction and tighten the center support bolt. | ||
| + | |||
| + | The center support snap ring has a taper on one side. The taper side is installed ''up'' as you look into the case. | ||
| + | |||
| + | |||
| + | Next is the intermediate clutch pack to install into the case with the proper snap ring. | ||
| + | |||
| + | |||
| + | [[file:T-400_intermed_clutch.jpg]] | ||
===Sprag design comparison=== | ===Sprag design comparison=== | ||
Your Privacy Choices