TH350 rebuild tech
| Line 119: | Line 119: | ||
| − | [[File:T-350_center_suport_sprag.jpg|thumb|300px|left|Photo shows center support with sprag and inner race.]] <br style="clear:both"/> | + | [[File:T-350_center_suport_sprag.jpg|thumb|300px|left|Photo shows center support with sprag(roller clutch) and inner race.]] <br style="clear:both"/> |
| + | |||
| + | |||
| + | |||
| + | The roller clutch must installed correctly with the edge of the roller clutch tangs match the inner receiving tangs of the center support. Install snap ring. There is a snap ring on both sides of the roller clutch. | ||
| + | |||
| + | [[File:T-350_assembled_low_support.jpg|thumb|300px|left|Installed sprag (roller clutch), watch orientation of tangs into the center support housing.]] <br style="clear:both"/> | ||
| Line 130: | Line 136: | ||
| − | + | Next you install the 4-tang thrust washer into the large splines of the low sprag inner race (picture below), and then the sun shell and gear assembly. | |
| + | [[File:T-350_center_support.jpg|thumb|300px|left|Center support, inner race, thrust washer shown.]] <br style="clear:both"/> | ||
| − | + | Before this step, for HD use, you would have wanted to install additional sun gear bushings, there will be 2 bushings on each end, and re-drill the lube holes as shown below. | |
Your Privacy Choices