TH350 rebuild tech
(→Variations of the TH350 family) |
(→Rear planetary unit install) |
||
| Line 96: | Line 96: | ||
[[File:T-350_anti-rattle_spring.jpg|thumb|300px|left|Anti rattle (clunk) spring shown in correct location; use assembly grease to hold in place]] <br style="clear:both"/> | [[File:T-350_anti-rattle_spring.jpg|thumb|300px|left|Anti rattle (clunk) spring shown in correct location; use assembly grease to hold in place]] <br style="clear:both"/> | ||
| − | Be sure the low sprag inner race is not brinelled or has any unusual wear. | + | Be sure the low sprag inner race is not brinelled or has any unusual wear. A center support from a 1987-present 700R4 or 4L60E (including the aftermarket case saver with a bolt-on outer plate held with torx head bolts) can be used in place of the stock center support since the roller clutch is wider. |
[[File:T-350_center_suport_sprag.jpg|thumb|300px|left|Photo shows center support with sprag (roller clutch) and inner race]] <br style="clear:both"/> | [[File:T-350_center_suport_sprag.jpg|thumb|300px|left|Photo shows center support with sprag (roller clutch) and inner race]] <br style="clear:both"/> | ||
Your Privacy Choices