Removing stuck fasteners
(→Hot and Cold) |
(→Metric Method) |
||
| Line 34: | Line 34: | ||
Hammer a close-fitting metric socket tightly on a SAE nut, or vice-versa. Then use breaker bar socket wrench (or longest you can fit in a cramped space) to turn it. | Hammer a close-fitting metric socket tightly on a SAE nut, or vice-versa. Then use breaker bar socket wrench (or longest you can fit in a cramped space) to turn it. | ||
| − | I've seen a product that works basically the same way, but the inside of the sockets are lined with sharpened flutes that are also angled to dig further into the rusted nut or bolt as you turn the wrench. | + | I've seen a product that works basically the same way, but the inside of the sockets are lined with sharpened flutes that are also angled to dig further into the rusted nut or bolt as you turn the wrench. These are called metric sockets, and bite extreemly well into round and rusty bolts and nuts, as the flutes are sharp and point counter clockwise. Think of what you would get if you made a mold of an extractor drill bit. |
==Hot and Cold== | ==Hot and Cold== | ||
Your Privacy Choices