Rebuild an alternator
From Crankshaft Coalition Wiki
(Minor clean up, format; add link) |
|||
| Line 1: | Line 1: | ||
| − | + | ||
==Introduction== | ==Introduction== | ||
These days alternators are getting more and more costly (up to several hundred dollars depending on the application) while intermediate rebuild kits are very inexpensive and once you've done it, very simple to do. | These days alternators are getting more and more costly (up to several hundred dollars depending on the application) while intermediate rebuild kits are very inexpensive and once you've done it, very simple to do. | ||
| Line 7: | Line 7: | ||
==Rebuild your alternator== | ==Rebuild your alternator== | ||
If you plan to rebuild your alternator, some easy steps to a DIY project are below. | If you plan to rebuild your alternator, some easy steps to a DIY project are below. | ||
| + | |||
| + | ==Types of alternators== | ||
| + | [[File:Alts.jpg]] | ||
| + | Here’s three different GM alternators, on the left is the '''10DN''' which uses an external regulator. In the center is the internally regulated 10SI (Systems Integrated) used from the later ’70s. The serrated end that makes it easy to spot. On the right is the CS130. | ||
| + | |||
| + | ===CS130D alternator=== | ||
| + | The connector is usually labeled PLFS or PLIS. The only wire used is the '''L''' position, it's connected to the dash light. Do not connect this to a 12 V source, as that will damage it. If a dash light isn't used, install a 50 to 80 ohm, 5 watt resistor in series to a ''switched'' power source. On connectors without any markings as to which wire/terminal is which, use the ''third position counted from the large end of the connector'' for the dash light or resistor. | ||
=== Removal and clean up === | === Removal and clean up === | ||
Your Privacy Choices