Quick-disconnect rear mount battery

From Crankshaft Coalition Wiki
Jump to: navigation, search
(Mounting)
(Undo revision 3485449 by 140.248.77.151 (talk))
 
Line 1: Line 1:
{{youcanedit}}
 
  
 
==Things you'll need==
 
==Things you'll need==
Line 31: Line 30:
 
When you have your design roughed out on the cardboard, cut and slice the card board, bend it to the shape of the finished product. Use tape to hold it in place and tweak as required until you are satisfied.
 
When you have your design roughed out on the cardboard, cut and slice the card board, bend it to the shape of the finished product. Use tape to hold it in place and tweak as required until you are satisfied.
  
Get a piece of 24" X 24" by 1/8" steel or 5/16" aluminum plate. Place the template you made above on the plate and using a center punch, punch each inside and outside corner and draw your connecting lines. Mark the holes for the switch, solenoid, and battery hold downs and drill those first. Those punch marks and lines will be used for you to line up the brake that will bend them. If you don't have a brake, you can always have the local sheet metal shop bend them for you. Weld in extra gusset plates for strength, then weld and grind the corners. Mount the assembly to the floor of the trunk in a level area. Install battery.  
+
Get a piece of 24" X 24" by 1/8" steel or 5/16" aluminum plate. Place the template you made above on the plate and using a center punch, punch each inside and outside corner and draw your connecting lines. Mark the holes for the switch, solenoid, and battery hold downs and drill those first. Those punch marks and lines will be used for you to line up the brake that will bend them. If you don't have a brake, you can always have the local sheet metal shop bend them for you. Weld in extra gusset plates for strength, then weld and grind the corners. Mount the assembly to the floor of the trunk in a level area. Install battery.
 
+
Hey there,
+
 
+
Your website was impressive, and I wanted to reach out directly :)
+
 
+
I notice you have no video attached on your website yet but wanted to give some inspiration:
+
 
+
We helped vesretta make a video on their website, and they got over $20,000 in new business in just 30 days. I want to do the same for you.
+
 
+
Would you mind if I send over a couple of examples?
+
 
+
Thanks,
+
 
+
Chris
+
 
+
==Supplies==
+
*[http://www.plastidip.com/ Plasti Dip]
+
[[Category:Electrical]]
+

Latest revision as of 08:29, 22 April 2024

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox