How to rebuild a Rochester Quadrajet 4MV carburetor
m (→B. Parts) |
m (Reorganization.) |
||
Line 359: | Line 359: | ||
---- | ---- | ||
''Coming soon.'' | ''Coming soon.'' | ||
− | |||
− | |||
− | |||
− | |||
Line 369: | Line 365: | ||
− | + | '''Cautionary Note:''' According to [http://www.hotrodders.com Hotrodders] forum member '''''cyclopsblown34''''': | |
+ | <blockquote>''"That nut on the backside of the carburetor base plate, do not overtighten it. Use a thread sealant tape or paste on it and don't wrench down hard on it, the casting is thin and will crack if over torqued. you can pretty much get it tight by feel, the sealant allows you to tighten it with less torque and still have a good seal." ^''</blockquote> | ||
===H. Tuning=== | ===H. Tuning=== |