How to rebuild a Rochester Quadrajet 4MV carburetor

Jump to: navigation, search

@@ Line 211: / Line 211: @@
 ----
-====Airhorn====
+====Accelerator Pump Actuator====
+====Choke and Linkage====
+====Air Horn and Metering Rods====
 ====Float Bowl====
+*Accelerator pump and spring
+*Gasket
+*Power piston pump, spring and rods
+*Check ball
+*Float assembly
+*Needle and seat
+*Jets
+*Fuel Filter Housing
+====Base Plate/Throttle Body====
+*Idle mixture screws
+*Gasket
@@ Line 235: / Line 252: @@
 :#Replacement
 :#Staking
-::*Procedure
+::<blockquote>''"It is not uncommon for the retainer to fail to positively secure the PP in its hole in and of itself. The solution is to take a chisel and gently stake the edge of the hole in one or two spots against the retainer." ^'' - '''''TommyK''''', [[http://www.hotrodders.com Hotrodders]] forum member.
@@ Line 249: / Line 266: @@
 ''The primary wells can be drilled and tapped for short screws that will cure them for good, although these wells seldom leak. ^5</blockquote>''
+Also please see post #48 on [http://www.hotrodders.com/forum/rochester-quadrajet-4mv-carburetor-removal-disassembly-rebuild-rookie-level-190558-4.html page 4] on the thread [http://www.hotrodders.com/forum/rochester-quadrajet-4mv-carburetor-removal-disassembly-rebuild-rookie-level-190558.html "Rochester Quadrajet 4MV Carburetor: Removal, Disassembly, Rebuild (Rookie Level")]
 =====Worn Shaft Bushings=====

Revision as of 20:17, 19 July 2011