How to rebuild a Rochester Quadrajet 4MV carburetor
m (Clean up.) |
m (→Worn Shaft Bushings) |
||
| Line 301: | Line 301: | ||
<blockquote>''How much is too much? If you get an erratic idle or if it's obviously worn out. There will be play in ALL of them, though and that's where determining how much is too much is tricky. But if it idles good, it's good to go, IMO." ^''</blockquote> | <blockquote>''How much is too much? If you get an erratic idle or if it's obviously worn out. There will be play in ALL of them, though and that's where determining how much is too much is tricky. But if it idles good, it's good to go, IMO." ^''</blockquote> | ||
| + | |||
| + | Worn throttle shafts are self inflicted. To avoid premature wear on any carburetor, set up the throttle return spring as shown in the 'Best Case' in this picture. [[http://www.hotrodders.com/gallery/data/500/2439throttle.jpg]] | ||
=====Cleaning Float Bowl Orifices===== | =====Cleaning Float Bowl Orifices===== | ||
Your Privacy Choices