How to rebuild a Rochester Quadrajet 4MV carburetor
From Crankshaft Coalition Wiki
m (Reverted edits by 184.101.66.248 (talk) to last revision by 73.6.210.153) |
(→Photos to be used if and where needed) |
||
| Line 352: | Line 352: | ||
=====Base/throttle plate===== | =====Base/throttle plate===== | ||
| − | {{Note1}}Sometimes the Q-jet base plate may be missing a screw or two (there are only two on most carbs; three at the most). While the base plate is "helped" being held on by the two long front intake manifold mounting bolts and the two long screws at the rear of the carb, it's still a good idea to replace the missing screws. Just be sure to not over tighten these long bolts. If they're over tightened, it can warp the carb permanently. | + | {{Note1}}Sometimes the Q-jet base plate may be missing a screw or two (there are only two on most carbs; three at the most). While the base plate is "helped" being held on by the two long front intake manifold mounting bolts and the two long screws at the rear of the carb, it's still a good idea to replace the missing screws. Just be sure to not over tighten these long bolts. If they're over tightened, it can warp the carb permanently. |
=====Float/fuel bowl===== | =====Float/fuel bowl===== | ||
| Line 665: | Line 665: | ||
[[File:CHOKE HOT AIR SEVERAL TYPES.jpg|thumb|300px|left|Several types of hot air choke housings]] | [[File:CHOKE HOT AIR SEVERAL TYPES.jpg|thumb|300px|left|Several types of hot air choke housings]] | ||
| − | |||
[[Category:Engine]] | [[Category:Engine]] | ||
[[Category:Carburetors]] | [[Category:Carburetors]] | ||
| − | |||
| − | |||
Your Privacy Choices