How to rebuild a Rochester Quadrajet 4MV carburetor
(→Throttle blade screw removal: Add text; minor clean up) |
(Add image) |
||
| Line 215: | Line 215: | ||
A common problem on the early (1968-back) Q-jets especially, is leaky main wells. The early leak-prone plugs can be identified by being brass cup-type plugs as opposed to aluminum. The late-type plugs are shown below, left- front plugs arrows, rear plugs circled. The 'cure' for this has long been to use JB Weld, etc. to seal them over. This is just a stop-gap measure, the epoxy will degrade and quit sealing. | A common problem on the early (1968-back) Q-jets especially, is leaky main wells. The early leak-prone plugs can be identified by being brass cup-type plugs as opposed to aluminum. The late-type plugs are shown below, left- front plugs arrows, rear plugs circled. The 'cure' for this has long been to use JB Weld, etc. to seal them over. This is just a stop-gap measure, the epoxy will degrade and quit sealing. | ||
| − | The well plug stop-leak pads that come in many rebuild kits are a joke (below, right). They will seal the leaking rear plugs for a few heat cycles before shrinking down to a fraction of their former thickness. The result is the carb will initially run as it should, ''quickly'' followed by the same symptoms of a leaky plug returning. Do not waste your time with them. If you have a leaking plug, repair it right. | + | The well plug stop-leak pads that come in many rebuild kits are a joke (below, center and right). They will seal the leaking rear plugs for a few heat cycles before shrinking down to a fraction of their former thickness. The result is the carb will initially run as it should, ''quickly'' followed by the same symptoms of a leaky plug returning. Do not waste your time with them. If you have a leaking plug, repair it right. |
| − | [[File:Q jet well plugs.jpg]][[File:WELL PLUG 1.jpg]] | + | [[File:Q jet well plugs.jpg|400px]][[File:WELL PLUG 1.jpg|295px]][[File:WELL PLUG 2.jpg]] |
FWIW, there is an epoxy by Devcon (made in the USA, look for "Devcon Home"). It comes in the older 2 tube packages and the newer double plunger syringe type. On the back it clearly states it <u>*RESISTS UNLEADED FUEL*</u>, salt, gasoline, oil etc. Full set time 8-12 hrs/2500 psi. However, be aware there is no empirical evidence that this epoxy will work for the life of the carb without any delamination or degradation. Ruggles also mentions using Marine Tex epoxy to seal the threads of replacement well plugs, but he states that using epoxy alone to repair a leaking well plug is akin to "cutting your arm off and putting a Band-Aid on it". | FWIW, there is an epoxy by Devcon (made in the USA, look for "Devcon Home"). It comes in the older 2 tube packages and the newer double plunger syringe type. On the back it clearly states it <u>*RESISTS UNLEADED FUEL*</u>, salt, gasoline, oil etc. Full set time 8-12 hrs/2500 psi. However, be aware there is no empirical evidence that this epoxy will work for the life of the carb without any delamination or degradation. Ruggles also mentions using Marine Tex epoxy to seal the threads of replacement well plugs, but he states that using epoxy alone to repair a leaking well plug is akin to "cutting your arm off and putting a Band-Aid on it". | ||
Your Privacy Choices