How to prep and start a rebuilt engine
From Crankshaft Coalition Wiki
| Line 1: | Line 1: | ||
| − | + | ||
==Engine assembly== | ==Engine assembly== | ||
===Bearings=== | ===Bearings=== | ||
| Line 66: | Line 66: | ||
# Run 5-6 medium-throttle accelerations to about 4500 rpm and letting off in gear and coasting back down to 2000 rpm. | # Run 5-6 medium-throttle accelerations to about 4500 rpm and letting off in gear and coasting back down to 2000 rpm. | ||
# Run a couple of hard-throttle acceleration to about 5000 rpm then letting off in gear and coasting back down to 2000 rpm. | # Run a couple of hard-throttle acceleration to about 5000 rpm then letting off in gear and coasting back down to 2000 rpm. | ||
| − | # Change the oil and filter | + | # Change the oil and filter |
# Drive the next 25 laps without high rpm’s (below 5000 rpm), hard use, or extended periods of high loading. | # Drive the next 25 laps without high rpm’s (below 5000 rpm), hard use, or extended periods of high loading. | ||
# Change the oil and filter again. | # Change the oil and filter again. | ||
Your Privacy Choices