How to cut steel braided cable
From Crankshaft Coalition Wiki
(Cold chisel not carpenter's) |
|||
| Line 6: | Line 6: | ||
Another easy way of doing it, if you don't have a cut-off wheel handy is with a cold chisel. Just wrap the cable with tape like described above to keep the threads from fraying. Set it on a solid piece of stock, or concrete works sometimes, put the cold chisel in the middle of your taped section and hit it with a hammer. It generally cuts very easily. Hope this helps. | Another easy way of doing it, if you don't have a cut-off wheel handy is with a cold chisel. Just wrap the cable with tape like described above to keep the threads from fraying. Set it on a solid piece of stock, or concrete works sometimes, put the cold chisel in the middle of your taped section and hit it with a hammer. It generally cuts very easily. Hope this helps. | ||
| + | |||
| + | I have found another way of cutting cable of less than 1/4 inch cleanly. Wrap the cable with electrical tape. Then take a block of hard wood (6 inch long 2 x 2 is ideal) and stand it up in a vice. Drill a hole a bit larger than the cable about 1 inch from the end. Turn the block 90 degrees and using the hacksaw cut down through the wood, past the hole. Feed the cable through the hole and cut. | ||
A word of caution - when using the cut off wheel, make sure you are wearing eye protection as little pieces of stainless steel will go flying. As far as bloody finger tip - sorry, you take your chances with braided cable, but good mechanics' gloves will help some. | A word of caution - when using the cut off wheel, make sure you are wearing eye protection as little pieces of stainless steel will go flying. As far as bloody finger tip - sorry, you take your chances with braided cable, but good mechanics' gloves will help some. | ||
Your Privacy Choices