Head gasket
m (→Head gasket torquing) |
m (→The process for re-torquing is as follows:: minor clean up) |
||
| Line 187: | Line 187: | ||
*Retracing the original torque pattern one fastener at a time, slightly loosen the bolt or nut (to overcome the friction set), then re-torque to the specified torque setting | *Retracing the original torque pattern one fastener at a time, slightly loosen the bolt or nut (to overcome the friction set), then re-torque to the specified torque setting | ||
| − | {{!}}It is suggested by some to retorque cast iron heads/blocks while still warm (not hot). Whether or not this | + | {{!}}It is suggested by some to retorque cast iron heads/blocks while still warm (not hot). Whether or not to do this when using iron castings is up to the builder (''research this beforehand''). But this should NOT be done with aluminum blocks or heads. |
===When replacing a blown head gasket=== | ===When replacing a blown head gasket=== | ||
Your Privacy Choices