Editing Frame swaps (section)
Jump to:
navigation
,
search
===Header/crossmember fitment=== There are headers available for the '91-'96 Dakota V8. Hooker makes 'em, part #5803, 1 5/8" primaries, long-tube. These are not shorties. Problem might be, this is a frame swap and there's no way of knowing how the headers will work with the International firewall and center frame portion, so here's how I might go about it to make sure they would work with the 360 in the International: I'd weld a piece of 2" X 2" square tubing on the bottom of the Dakota clip cross member and extend it toward the rear of the clip. You can cut it off with your gas axe and grind it smooth later when the swap is complete. I'd build a transmission tail shaft mount on it and install a caster wheel on the bottom of the tubing under the transmission mount, so that the whole clip rolls on the front wheels/tires of the Dakota clip and the caster wheel at the rear of the 2 x 2 (building, in effect a 3-point roller). You'd want to install the caster wheel so that the fore/aft tilt of the clip was the same as factory so that the front suspension geometry (caster) would be unaffected and install the transmission mount so that the motor/transmission has a 3 degree tilt to the rear. I'd mount the motor and trans I was going to eventually use in the swap into the clip and install the headers on the motor. This way, you could roll the entire clip/motor/transmission into place for connecting to the International frame mid-section and be assured that the engine/firewall, transmission/tunnel and header/frame/body clearance would be good to go and that the motor/trans would have the correct 3 degree back tilt to them. This assumes, of course, that your workspace floor is level. Hopefully, you'll be able to position the centerline of the front wheels/tires somewhere close to the point you determined when "eyeballing" the front wheel/tire position on the International that looked best.
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent