Ford C4 transmissions

Jump to: navigation, search

@@ Line 1: / Line 1: @@
 {{newarticle}}
-How many qts of trans fluid is in a C4 trans in a F150 2WD 1978
+=Rebuild and assembly of a Ford C-4 transmission=
+===Basic rebuild information===
+This WIKI is not intended to be a replacement for an ATSG  tech manual. First time builders will likely need a tech manual.
+This is not a step-by step pictorial, don't assume it is shown where every part goes.
+=Main case prep work=
+Rear side of main case. This photo shows the placement of the parking pawl , pin and spring for the pawl.
 [[file:Medium_0180.jpg]]
-[[file:C-4_build_-_04.jpg]]
+=Parking pawl wheel and thrust washer=
+Thrust washer for parking pawl wheel shown in photo
 [[file:C-4_build_-_02.jpg]]
+Parking pawl wheel with thrust washer installed.  Washer held in place with assembly grease
+[[file:C-4_build_-_04.jpg]]
@@ Line 13: / Line 31: @@
 [[file:C-4_build_-_08.jpg]]
+[[file:C-4_build_-_24.jpg]]
 [[file:C-4_build_-_09.jpg]]
+Snap ring installed on the out put shaft. Snap ring sets on top of the rear ring gear before the rear planet is installed.This retains the shaft into the transmission.
 [[file:C-4_build_-_14.jpg]]
+Thrust washer installed on rear planetary unit
 [[file:C-4_build_-_15.jpg]]

Revision as of 23:58, 24 September 2011