Fat-fendered Ford battery tray

Jump to: navigation, search
m (Preamble)
m (How to build it)
Line 10: Line 10:
  
 
==How to build it==
 
==How to build it==
Begin by making a small cardboard box, approimately the size of the battery you'll be using. A cardboard mock-up is easier to handle than a regular 40-pound acid-filled battery. Making it an inch or so larger will give you additional clearances for cables and hold-downs.
+
Begin by making a small cardboard box, approimately the size of the new battery. The mock-up is easier to handle than a regular 40-pound acid-filled battery and making it an inch or so larger will cover additional clearances for cables and hold-downs.
  
 
Place the box against the frame area and try to imagine what kind of bracket will be required to hold it there. Duct tape can secure the box in place while flexible steel strapping (usually found on packing crates) can be shaped into 90 degree bends to support the battery.  
 
Place the box against the frame area and try to imagine what kind of bracket will be required to hold it there. Duct tape can secure the box in place while flexible steel strapping (usually found on packing crates) can be shaped into 90 degree bends to support the battery.  
  
The location should be a place where you can access the battery for servicing or removal and where potential damage from flying debris, i.e. stones and such, is at a minimum. An accessory shield can be added to further protect the battery casing. Ideally, the frame of the vehicle should be close to this location as it is one of the strongest mounting points available.
+
The location should be easily accessible for servicing or removal yet protected from potential damage from stones and other debris. An accessory shield can be added to further protect the battery casing. Ideally, the frame of the vehicle should be close to this location as it is one of the strongest mounting points available.
  
"What about water and dampness?" you ask. Well, most modern batteries are sealed, maintainance-free units, 99 percent impervious to outside water sources and cable connections can be coated with dielectric grease to seal out corrosion. In addition, you can put your battery in a plastic marine battery case, which will provide both waterproofing and protection from physical damage.
+
"What about water and dampness?" you ask. Well, most modern batteries are sealed, maintenance-free units, 99 percent impervious to outside water sources and cable connections can be coated with dielectric grease to seal out corrosion. In addition, you can put your battery in a plastic marine battery case, which will provide both waterproofing and protection from physical damage.
  
 
A plastic marine battery case can be used in place of the cardboard box to find your location.
 
A plastic marine battery case can be used in place of the cardboard box to find your location.

Revision as of 20:22, 12 February 2010

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox