Editing Compression test

{{Youcanedit}} ==To check compression:== '''Disable spark and fuel''' Ideally, warm up the engine first. Piston and rings are designed to provide optimum sealing at operating temperature. On a vehicle with a electric fuel pump pull the fuel pump relay, let engine idle until it stalls out. For mechanical fuel pump, I think using a vise grip and 2 thin blocks of wood (to avoid crimping the soft line) on the rubber fuel line will work. This prevents fire hazard. Remove the coil wire, or ECM fuse or wiring harness clip off the coil for computerized engines,- by allowing the coils to be energized you could get a serious jolt! '''Pull the spark plugs''' Keep track where they came from and 'read' them while you're at it. Labeling your plug wires will help keep track of which cylinder they go to to assist in buttoning this all back together. '''Have someone hold throttle open.''' Pulling the plugs and open throttle will allow the the starter motor to crank the engine faster (less leak down) and the test cylinder to fill with air, produce a more accurate reading. '''Hook up compression tester''' The compression tester fitting threads into the spark plug hole, and many models also have a vacuum gauge function as well. Crank the engine over for 10 seconds, and record maximum pressure reading. Record your findings. Move onto the next cylinder, repeat the compression test, and when you're done they should not be more than 10% off from each other, and none should be really low (0). If they are, you have some problems. ==Static compression ratio== *[http://www.wheelspin.net/calc/calc2.html SCR] ==Dynamic compression ratio== *[http://www.wallaceracing.com/dynamic-cr.php Wallace Racing DCR calculator] *[http://www.empirenet.com/pkelley2/DynamicCR.html Kelly DCR calculator] *[http://www.uempistons.com/calc.php?action=comp2 KB/Silvolite DCR calculator] *[http://www.rbracing-rsr.com/comprAdvHD.htm RSR DCR calculator] {{Note1}} Some dynamic compression rtatio calculators (like KBs) ask for an additional 15 degrees of duration be added to the IVC @ 0.050" lift point figure. This works OK on older, slower ramped cam lobes, but the faster lobe profiles may need to have 25 degrees or more added to be accurate. {{Note1}}If the intake valve closing (IVC) point isn't known, it can be calculated: # Divide the intake duration by 2 # Add the results to the lobe separation angle (LSA) # Subtract any ground-in advance # Subtract 180 This result does not need to have any amount added to the IVC point, like the KB calculator calls for. ==Resources== *'''[[Vacuum gauge engine diagnosis]]''' *'''[[Finding vacuum leaks]]''' [[Category:Engine]] [[Category:Troubleshooting]]

| Editing help (opens in new window)