Adjusting hydraulic lifters

Jump to: navigation, search

@@ Line 27: / Line 27: @@
 '''6.''' Both valves on this cylinder are now adjusted, and you can move on to your next cylinder and follow the same procedure again.
-Something that you also might want to do is [url= http://www.crankshaftcoalition.com/wiki/How_to_make_a_timing_tape] ‘’’MAKE A TIMING TAPE’’’[/url]. This temporary timing tape will allow you to check and set the total timing even if you don't have a timing light that reads advance or a degreed damper. You can also use it to permanently mark the damper for full advance, etc. as you see fit.
+Something that you also might want to do is go to [url= http://www.crankshaftcoalition.com/wiki/How_to_make_a_timing_tape] [['''How To Make A Timing Tape''']]. This temporary timing tape will allow you to check and set the total timing even if you don't have a timing light that reads advance or a degreed damper. You can also use it to permanently mark the damper for full advance, etc. as you see fit.
-If there's any doubt as to whether or not the timing mark on the damper and the timing tab is accurate, you can [url=http://www.crankshaftcoalition.com/wiki/Determining_top_dead_center] ‘’’DETERMINE TDC’’’[/url].
+If there's any doubt as to whether or not the timing mark on the damper and the timing tab is accurate, you can use [['''Determining Top Dead Center''']] to be sure of your markings.
 [[Category:Good articles]]
 [[Category:Engine]]

Revision as of 09:53, 21 June 2010