1937-1957 Buick Oldsmobile Pontiac suspension upgrade

Jump to: navigation, search
(Front suspension)
Line 110: Line 110:
  
  
For spindles, the '63 Pontiac spindles advised in the article were used.The '63 Pontiac spindle has a deep 90 degree bend at the bottom, to clear the wide corners on the lower control arm. (The '60s stock Chevy spindle has a 45 degree angle at that location, so Chevy Spindles won't work.)  Unfortunately, when it was set it on the ground, the front ride height was too high.  This led to a search for dropped spindles.  
+
For spindles, the '63 Pontiac spindles advised in the article were used.
Note the side by side comparisons in the picture. 
+
The '63 Pontiac spindle has a deep 90 degree bend at the bottom, to clear the wide corners on the lower control arm. (The '60s stock Chevy spindle has a 45 degree angle at that location, so Chevy Spindles won't work.)  Unfortunately, when it was set it on the ground, the front ride height was too high.  This led to a search for dropped spindles.  
For BOP, dropped spindles couldn't be found
+
For BOP, dropped spindles couldn't be found but Chevy drop spindles are readily available.
Chevy drop spindles are readily available.
+
 
 +
Note the side by side comparisons in the picture.
 
{|
 
{|
 
|[[image:63_pontiac_65_chevy_spindle_2.jpg|thumb|center|400px|Pontiac (bottom) vs. Chevy spindle shape]]
 
|[[image:63_pontiac_65_chevy_spindle_2.jpg|thumb|center|400px|Pontiac (bottom) vs. Chevy spindle shape]]
 
|[[image:Cpp_-_Pont_-_chevy_spindles.jpg|thumb|center|400px|CPP custom spindle/Pontiac/Chevy]]
 
|[[image:Cpp_-_Pont_-_chevy_spindles.jpg|thumb|center|400px|CPP custom spindle/Pontiac/Chevy]]
 
|}
 
|}
 +
 +
The spindle on the left, shown above is the '65-'70 Chevy drop spindle from Classic Performance Products. It's their own in-house design and is very close to the design of a Pontiac spindle.
  
  
The third spindle shown below is the '65-'70 Chevy drop spindle from Classic Performance Products. It's their own in-house design and is very close to the design of a Pontiac spindle. The ears had to be trimmed off the front side of the lower A-frame, but that was a minor modification.
+
The ears had to be trimmed off the front side of the lower A-frame, but that was a minor modification.
 
   
 
   
 
[[image:IMGP0005.JPG|thumb|left|400px|Trimmed lower control arm]] <br style="clear:both"/>
 
[[image:IMGP0005.JPG|thumb|left|400px|Trimmed lower control arm]] <br style="clear:both"/>

Revision as of 08:24, 28 October 2016

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox