How do turn signals work?

Jump to: navigation, search
(Power feed and flash unit)
Line 14: Line 14:
  
 
The flasher operates from internal heat on a tungsten bi-metallic "strip" that makes or breaks the contact at the switch side (or "power output" side) of the contact.
 
The flasher operates from internal heat on a tungsten bi-metallic "strip" that makes or breaks the contact at the switch side (or "power output" side) of the contact.
 
+
The bi-metallic strip functions as it does by two dissimilar metals (Bi-metallic) with dissimilar expansion rates causing it to bend.
 
As the system lamp load is imposed on the flasher unit, the bimetallic strip heats up, and curls upwards, breaking contact to the switch. It then cools down very rapidly, and makes contact again, and the lamp load again heats the strip and it opens up. Thus: flash.
 
As the system lamp load is imposed on the flasher unit, the bimetallic strip heats up, and curls upwards, breaking contact to the switch. It then cools down very rapidly, and makes contact again, and the lamp load again heats the strip and it opens up. Thus: flash.
  
Line 38: Line 38:
  
 
The net result usually is a very rapid flash rate. And, in some cases, failure of the flasher unit, or premature failures on subsequent units.
 
The net result usually is a very rapid flash rate. And, in some cases, failure of the flasher unit, or premature failures on subsequent units.
 
  
 
==The turn signal switch==
 
==The turn signal switch==

Revision as of 13:42, 31 January 2007

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox