Window removal and installation

Jump to: navigation, search
(Installing the new window)
(Installing flush mounted glass)
Line 32: Line 32:
  
 
== Installing flush mounted glass ==
 
== Installing flush mounted glass ==
 +
 +
 +
You can install windshield glass in most any car that had a windshield frame or rubber molding using the S-10 filler strip and an adhesive as long as the pinch weld is behind the glass. I prefer to use urethane or silicone instead of butyl tape due to the irregularities in the flange or pinchweld that backs up the windshield.
 +
 +
The basic procedure is to get your pinchweld all cleaned up and any voids filled. If there were slots or notches for hinges etc they need to be filled. Obviously rust and loose paint needs to be removed. A coat of epoxy primer is a good idea.
 +
Have your glass cut so that you have about 1/4 gap between the edge of the glass and the windshield opening. No more than 17/64" and no less than 15/64" gap all around. I always trial fit my filler strip before I do the install to make sure it isn't too tight or loose. Too tight and the glass may crack or pop out during installation and too loose and you will have gaps.
 +
 +
You can paint a uniform band around the edge of the glass with Dow betaprime 5500 pinchweld primer. This material will create a dark band around the edge of the glass similar to the baked on ceramic frit you see on most all of the newer cars. Mask off 1/2"to 3/4" uniformly around the edge so it will look good from the outside. I usually mask off inside of my frit line so as to have a nice line to cut my setting adhesive to.
 +
 +
Position the glass so that it is flush with the body using at least 6 rubber setting blocks 1 in each corner and 2 in the middle.. You want the glass to sit evenly on these blocks .You can maintain your 1/4" gap with some scraps of filler strip or wooden spacers, removing them as you install the strip.
 +
 +
Once the windshield is positioned Install the filler strip using super weather strip adhesive on at least one side of the strip. You can make a butt joint in the middle of the strip at the bottom of the window. I try to not mitre corners unless I absolutly have to because it is very hard to keep the edges down. I usually glue the ends with super glue. Once the filler strip is installed backfill the space behind the windshield with urethane adhesive, tool it so it looks nice and has no voids. Let it cure and you are done.
 +
 +
That is a fairly simple set of instructions, there may be other things that need to be considered such as what to do about your dash and header panel, etc. Is the windshield 2 pieces? this may require a center seam.
 +
Most of the better glass shops will be able to get you the required supplies and may give you some better specific instructions for your particular application.
  
 
== Tips and tricks ==
 
== Tips and tricks ==

Revision as of 07:31, 11 September 2006

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox