TH350 rebuild tech

Jump to: navigation, search
(Intermediate clutch clearance)
Line 299: Line 299:
 
After the pump is set into place to test end play clearance, you can also check the clutch clearance on the intermediate clutch pack. Clearance of 0.050" to 0.070" will work well. There are thicker intermediate steel plates available if need to tighten up the clutch pack clearance. Intermediate steels [[media:Usgmth35004.pdf|'''are available''']] (see page 40) in 0.068", 0.078" and 0.089" thicknesses, some manufacturers may use slightly different thicknesses than these.  
 
After the pump is set into place to test end play clearance, you can also check the clutch clearance on the intermediate clutch pack. Clearance of 0.050" to 0.070" will work well. There are thicker intermediate steel plates available if need to tighten up the clutch pack clearance. Intermediate steels [[media:Usgmth35004.pdf|'''are available''']] (see page 40) in 0.068", 0.078" and 0.089" thicknesses, some manufacturers may use slightly different thicknesses than these.  
  
Also, a scraped low-reverse friction can be used under the intermediate friction if need be. A scraped friction will measure about 0.032".
+
Also, a scrapped low-reverse friction can be used under the intermediate friction if need be. A scraped friction will measure about 0.032".
  
 
[[File:T-350_intermed_clearance_ck.jpg|thumb|300px|left|TH350 intermediate clutch pack clearance can be checked through this hole]] <br style="clear:both"/>
 
[[File:T-350_intermed_clearance_ck.jpg|thumb|300px|left|TH350 intermediate clutch pack clearance can be checked through this hole]] <br style="clear:both"/>

Revision as of 15:56, 28 April 2015

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox