Window removal and installation

Jump to: navigation, search
(Tips and tricks)
(Rubber seal type)
Line 22: Line 22:
 
Say you want to remove the front windshield of your 1950's car. Get inside the vehicle and start at the top. Use a flat blade screw driver starting in the middle and working towards one side of the car. Push the old rubber seal over the pinchweld. Once you get to the side of the car, start again at the top in the middle working the rubber over the pinchweld to the opposite side of the car.
 
Say you want to remove the front windshield of your 1950's car. Get inside the vehicle and start at the top. Use a flat blade screw driver starting in the middle and working towards one side of the car. Push the old rubber seal over the pinchweld. Once you get to the side of the car, start again at the top in the middle working the rubber over the pinchweld to the opposite side of the car.
  
After you've worked to both sides of the car, the windshield can then be pushed free of the body. Just don't push TOO hard or you may find the glass laying on the ground in pieces?
+
After you've worked to both sides of the car, the windshield can then be pushed free of the body. Just don't push TOO hard or you may find the glass laying on the ground in pieces.
  
 
Now the windshield will be out of the car. You didn't cut your hand with a knife, and this method really doesn't take any longer then using a knife to cut the old seal.
 
Now the windshield will be out of the car. You didn't cut your hand with a knife, and this method really doesn't take any longer then using a knife to cut the old seal.

Revision as of 02:18, 24 January 2010

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox