How do turn signals work?

Jump to: navigation, search
(The turn signal switch)
(FIELD_OTHER)
Line 127: Line 127:
 
#If the plugs look good, go to the lamp buckets, and measure between the socket ground and a known good ground. If it shows 12 volts, you may have an open ground wire. Replace or install a ground from each socket to a hard frame ground, following proper bonding procedures (star washers and burnishing).
 
#If the plugs look good, go to the lamp buckets, and measure between the socket ground and a known good ground. If it shows 12 volts, you may have an open ground wire. Replace or install a ground from each socket to a hard frame ground, following proper bonding procedures (star washers and burnishing).
  
===Left or right side turn signals dead===
+
FIELD_MESSAGE_c4tcoreln
Follow the same procedure as outlined for front or rear dead above. However, apply it to the affected side.
+
 
+
  
 
===All rear turn signals flashing===
 
===All rear turn signals flashing===

Revision as of 23:53, 16 December 2008

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox