Camshaft install tips and tricks
(→Engine RPM for break in) |
|||
| Line 128: | Line 128: | ||
Used lifters should only be used on the very same cam, in the very same block, and in the very same positions they were removed from. Chances that the lifter bores will be machined on the very same angles on a different block as the block the lifters came out of are about equal to you hitting the lottery. If you purchase a used flat tappet cam from a swap meet or yard sale, plan on using it for a doorstop. New lifters should not be used on an old cam, either. Given the reasonable cost of a new cam and lifter set (~$100 ca. 2012), vs. the cost of cleaning and repairing the damage done by a failed cam and lifters, the choice to use new parts is obvious. | Used lifters should only be used on the very same cam, in the very same block, and in the very same positions they were removed from. Chances that the lifter bores will be machined on the very same angles on a different block as the block the lifters came out of are about equal to you hitting the lottery. If you purchase a used flat tappet cam from a swap meet or yard sale, plan on using it for a doorstop. New lifters should not be used on an old cam, either. Given the reasonable cost of a new cam and lifter set (~$100 ca. 2012), vs. the cost of cleaning and repairing the damage done by a failed cam and lifters, the choice to use new parts is obvious. | ||
| + | |||
| + | |||
| + | '''19. Failure to observe the lifters and pushrods turning with the motor running.''' | ||
| + | If the lifter is not turning, the cam lobe is hitting on the same spot on the lifter every revolution and it won't be long until the lifter yields and then takes the lobe out with it. All lifters and all pushrods must be turning for successful engine operation. | ||
| + | |||
==Lubrication== | ==Lubrication== | ||
Your Privacy Choices