How do turn signals work?
(→Dead system) |
(→Front signals work, but rear signals are dead (or vice-versa)) |
||
Line 138: | Line 138: | ||
===Front signals work, but rear signals are dead (or vice-versa)=== | ===Front signals work, but rear signals are dead (or vice-versa)=== | ||
− | #Isolate the two wires on the effected end from the column plug. Using your voltmeter, set to the above parameters, select a side, and measure the wire from the plug. It should show 12 volts (solid or intermittent). If | + | #Isolate the two wires on the effected end from the column plug. Using your voltmeter, set to the above parameters, select a side, and measure the wire from the plug. It should show 12 volts (solid or intermittent). If |
− | + | ||
− | + | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | the socket ground and a known good ground. If it shows 12 volts, you may have an open ground wire. Replace or install a ground from each socket to a hard frame ground, following proper bonding procedures (star washers and burnishing). | ||
===Left or right side turn signals dead=== | ===Left or right side turn signals dead=== |