Editing How to get 350 to tdc with heads off
Line 1: | Line 1: | ||
− | + | How do i get my 350 to tdc with the heads off.. | |
+ | |||
+ | |||
+ | '''You bolt ''' on a piston stop to the deck of the block ... I would suggest you do that on piston number 1. | ||
+ | |||
+ | Bolt a degree wheel onto the crank shaft.. with a pointer. Rotate the engine crank around till the piston hits the stop. Mark the location on the degree wheel. | ||
+ | |||
+ | Rotate the crank shaft the other direction till the piston hits the stop again, note the location the degree wheel. | ||
+ | |||
+ | Split the two marks on the degree wheel in half... that is TDC |