How to make "speed holes" using dimple dies
From Crankshaft Coalition Wiki
m (Reverted edits by 74.82.132.3 (talk) to last revision by Cobalt327) |
(→How to make 'em) |
||
Line 31: | Line 31: | ||
− | If you were making a bracket that required stiffening to make it | + | If you were making a bracket that required stiffening to make it rigid, this is what you would end up with after making a series of holes and using the dimpling dies. A rigid panel that would flow air through it, not hold air back. |
[[File:Pickup_panel.jpg|border|400px]] | [[File:Pickup_panel.jpg|border|400px]] | ||
[[File:Rad_cradle.JPG|border|400px]] | [[File:Rad_cradle.JPG|border|400px]] | ||
[[File:Brackets.JPG]] | [[File:Brackets.JPG]] | ||
− | |||
===Here's another way to do 'em=== | ===Here's another way to do 'em=== |