How to make "speed holes" using dimple dies
(→WHERE TO GET THE DIMPLING DIES) |
|||
Line 42: | Line 42: | ||
[[File:Brackets.JPG]] | [[File:Brackets.JPG]] | ||
+ | |||
+ | |||
+ | '''And Here's Another Way To Do 'em''' | ||
+ | |||
+ | 1. Layout a sheet of metal with the center lines marked horizontal and vertical (spacing). | ||
+ | |||
+ | |||
+ | [[File:IMG_2466.JPG]] [[File:IMG_2474.JPG]] | ||
+ | |||
+ | |||
+ | |||
+ | 2. Fit the hole cutter on for the appropriate size of center that you would like through a pre-drilled hole (3/8 or 1/2 inch) | ||
+ | |||
+ | |||
+ | [[File:IMG_2468.JPG]] [[File:IMG_2477.JPG]] | ||
+ | |||
+ | |||
+ | |||
+ | 3. Tighten down on bolt using a pneumatic gun and wrench until die cuts through material. | ||
+ | |||
+ | |||
+ | [[File:IMG_2481.JPG]] [[File:IMG_2482.JPG]] | ||