How to make "speed holes" using dimple dies
Line 31: | Line 31: | ||
− | If you were making a bracket that required stiffing to make it ridged, this is what you would end up with after making a series of holes and using the dimpling dies. A ridged panel that would flow air through it, hold air back. | + | If you were making a bracket that required stiffing to make it ridged, this is what you would end up with after making a series of holes and using the dimpling dies. A ridged panel that would flow air through it, not hold air back. |
[[File:Pickup_panel.jpg]] | [[File:Pickup_panel.jpg]] | ||
+ | |||
+ | |||
+ | [[File:Rad_cradle.JPG]] | ||
+ | |||
+ | |||
+ | |||
+ | [[File:Brackets.JPG]] | ||
Line 42: | Line 49: | ||
Check these guys out: http://www.kartek.com/Product/Tools/DippleDie.html | Check these guys out: http://www.kartek.com/Product/Tools/DippleDie.html | ||
+ | Flared hole dies: http://www.lightracing.com/lightracingFlaredHoleDies.html | ||
+ | Sets of dies: http://www.vansantent.com/sheet_metal_machines/dimple_dies.htm | ||