How to rebuild a Rochester Quadrajet 4MV carburetor
(Minor clean up of portions attributed to Cobalt327) |
(→Photos to be used if and where needed: clarify caption) |
||
Line 564: | Line 564: | ||
=Photos to be used if and where needed= | =Photos to be used if and where needed= | ||
− | [[File:Q-JET BANJO FUEL INLET FITTING ON CARB.jpg|thumb|300px|left| | + | [[File:Q-JET BANJO FUEL INLET FITTING ON CARB.jpg|thumb|300px|left|"Banjo" fitting used to make a straight fuel inlet into a 90 degree inlet]] |
− | [[File:Q-JET FILTER HOUSING GASKETS.jpg|thumb|300px|left| | + | [[File:Q-JET FILTER HOUSING GASKETS.jpg|thumb|300px|left|The two most used carb filter housing gaskets. Earliest was 7/8" (and are rare), later were all 1", early had gasket over the threads, late style had white gasket on end of housing before threads]] |
− | [[File:REBUILT CARB TELL-TAIL PIN TO BLOCK INCORRECT AIR CLEANER STUD INSTALLATION.jpg|thumb|300px|left|Dead give-away of a rebuilt carb: Arrow points to tell-tail pin installed by rebuilders to keep the air cleaner stud from being inserted into the wrong hole | + | [[File:REBUILT CARB TELL-TAIL PIN TO BLOCK INCORRECT AIR CLEANER STUD INSTALLATION.jpg|thumb|300px|left|Dead give-away of a rebuilt carb: Arrow points to tell-tail pin installed by rebuilders to keep the air cleaner stud from being inserted into the wrong hole]] |
− | [[File:TYPICAL MANUAL TRANS Q-JET THROTTLE ARM.jpg|thumb|300px|left|Manual or TH400 trans throttle arm that's missing the portion below the throttle shaft centerline where the detent/TV cable would be attached | + | [[File:TYPICAL MANUAL TRANS Q-JET THROTTLE ARM.jpg|thumb|300px|left|Manual or TH400 trans throttle arm that's missing the portion below the throttle shaft centerline where the detent/TV cable would be attached]] |
− | [[File:Secondary rods 002.jpg|thumb|300px|left|Selection of secondary metering rods: Lean left, rich middle, medium right | + | [[File:Secondary rods 002.jpg|thumb|300px|left|Selection of secondary metering rods: Lean left, rich middle, medium right]] |
− | [[File:CHOKE BIMETAL COILS 2.jpg|thumb|300px|left|Several types of hot air choke thermostats | + | [[File:CHOKE BIMETAL COILS 2.jpg|thumb|300px|left|Several types of hot air choke thermostats]] |
− | [[File:CHOKE HOT AIR SEVERAL TYPES.jpg|thumb|300px|left|Several types of hot air choke housings | + | [[File:CHOKE HOT AIR SEVERAL TYPES.jpg|thumb|300px|left|Several types of hot air choke housings]] |