Vortec L31 cylinder head
(→Intake gaskets) |
(→Using an early style intake on an aftermarket Vortec-type head) |
||
Line 379: | Line 379: | ||
Many aftermarket Vortec style heads (including Bow Tie Vortec heads) feature dual bolt patterns allowing the use of the early 12-bolt intakes. This has a very limited use. | Many aftermarket Vortec style heads (including Bow Tie Vortec heads) feature dual bolt patterns allowing the use of the early 12-bolt intakes. This has a very limited use. | ||
− | Commonly available 12 bolt SBC dual plane intakes do not have enough metal above the port to be ported to match the Vortec port, w/o having a vacuum leak or razor thin sealing surfaces above the ports. An early intake would need at least 0.325" of material above the intake port opening to have any chance of sealing, and that doesn't take the difference in the port width/location into account. | + | Commonly available 12 bolt SBC dual plane intakes do not have enough metal above the port to be ported to match the Vortec port, w/o having a vacuum leak or razor thin sealing surfaces above the ports. An early intake would need at least 0.325" of material above the intake port opening to have any chance of sealing, and that doesn't take the difference in the port width/location into account. Because of the height of the Vortec intake port, only the single plane 'raised port' race intakes have enough height to actually match up to the Vortec head intake port- but even then the ports may be too wide or have other fitment issues. |
Because of these differences, a Vortec-specific intake should be used. | Because of these differences, a Vortec-specific intake should be used. |