Window removal and installation
(→Factory glued-in glass) |
(→Windshield using rubber seal) |
||
| Line 83: | Line 83: | ||
# Wipe off lubricant with a dry rag, wash off the remainder with a wet rag. | # Wipe off lubricant with a dry rag, wash off the remainder with a wet rag. | ||
| − | Sometimes when pulling the rope the rubber does not pull inside the flange. The factory tool to pull the missed spot inside was made from a straight blade screwdriver. The flat portion was cut off then 1/4 inch ball was turned on the end. A 2 inch long taper was turned from the neck at the ball back towards the handle, then it was polished with fine sandpaper. The end was then heated and bent with about a 1 inch L leg. Use lube or a soap solution and work the ball end under the rubber and pull it out without tearing it. | + | Sometimes when pulling the rope the rubber does not pull inside the flange. The factory tool to pull the missed spot inside was made from a straight blade screwdriver. The flat portion was cut off then 1/4 inch ball was turned on the end. A 2 inch long taper was turned from the neck at the ball back towards the handle, then it was polished with fine sandpaper. The end was then heated and bent with about a 1 inch L leg. Use lube or a soap solution and work the ball end under the rubber and pull it out without tearing it. |
| + | These days there are plastic tools meant for trim removal which work well for glass installation with less risk of cracking the glass than a metal tool. Some installers even forgo using rope and use only one such tool and some soapy water. This isn't possible in all applications but a quite common way to install simpler glass like the back windows of many pre-1999 or so model pickup trucks, especially those metal-framed sliding glass windows. | ||
==Installing flush mounted glass== | ==Installing flush mounted glass== | ||
Your Privacy Choices