Straightening a rear end housing
(→Related information) |
|||
| Line 23: | Line 23: | ||
[[Image:PICT0040.JPG|frame|none|9" Ford center section with inserts and bar.]] | [[Image:PICT0040.JPG|frame|none|9" Ford center section with inserts and bar.]] | ||
| + | |||
| + | Another way to determine if the housing is straight is to machine the inserts for the diff center with a small center hole, clamp these in and install centre in housing.Then usng a sheet of paper with a small hole held at the bearing end site through and line up with two holes that are in the center then run your finger around the tube end marking the paper. find the center of you mark and this will show you how far your diff is out by comparing the hole in the paper to the centre. | ||
==Measuring== | ==Measuring== | ||
Your Privacy Choices