Crankshaft Coalition Wiki
(→New articles) |
|||
| Line 5: | Line 5: | ||
==New articles== | ==New articles== | ||
| + | ===*[[Make a fiberglass fan shroud]]=== | ||
| + | How to build a fiberglass fan shroud. From start to finish, with over 60 large photos. | ||
| + | |||
| + | {| | ||
| + | |- | ||
| + | |[[Image:261_Starliner_rad_rh.JPG|thumb|left|Radiator in a 1961 Ford Galaxie needs a fan shroud.]] | ||
| + | |[[Image:8laying out the circle.JPG|thumb|left|Using pieces of foam to shape the design.]] | ||
| + | |[[Image:30rolling out the air.JPG|thumb|left|Applying the fiberglass mat.]] | ||
| + | |[[Image:Spraying primer|thumb|left|Spraying the primer.]] | ||
| + | |} | ||
| + | |||
*[[Rebuilding an early Hemi engine]] | *[[Rebuilding an early Hemi engine]] | ||
*[[Early Hemi engine specifications]] | *[[Early Hemi engine specifications]] | ||
| Line 12: | Line 23: | ||
*[[Health and Safety in the Shop or Garage]] | *[[Health and Safety in the Shop or Garage]] | ||
*[[Hot rodding the HEI distributor]] | *[[Hot rodding the HEI distributor]] | ||
| + | *[[Basic stuff for newbies]] | ||
| + | *[[NHRA-legal Roll Bar]] | ||
| + | *[[Ford 144-250 inline 6 High performance building]] | ||
==Good articles== | ==Good articles== | ||
| + | |||
===[[Straightening a rear end housing]]=== | ===[[Straightening a rear end housing]]=== | ||
| − | + | How to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands. Full article: [[Straightening a rear end housing]]. | |
{| | {| | ||
| Line 26: | Line 41: | ||
===[[Steering shaft assemblies from junkyard parts]]=== | ===[[Steering shaft assemblies from junkyard parts]]=== | ||
| − | + | How to safely build steering shaft assemblies from scavenged GM parts, using Double D (DD) steering shafts and tubes. Full article: [[Steering shaft assemblies from junkyard parts]]. | |
{| | {| | ||
Your Privacy Choices