Valve train points to check

From Crankshaft Coalition Wiki
Jump to: navigation, search
(Areas of the valve train that need to be checked and verified)
m
 
Line 43: Line 43:
 
**Also see '''[[Quench]]'''
 
**Also see '''[[Quench]]'''
 
*Push rod to guide slot in head (see image below)  
 
*Push rod to guide slot in head (see image below)  
*Use '''EITHER''' self-aligning rockers '''OR''' pushrod guide slots in head '''OR''' guide plates, not two or more of these at the same time
+
*Use '''EITHER''' self-aligning rockers '''OR''' pushrod guide slots in head '''OR''' guide plates, but ''NEVER'' two or more of these at the same time
 
*"Rails" of self aligning rockers to retainer and/or locks
 
*"Rails" of self aligning rockers to retainer and/or locks
 
*Rocker to valve tip (if needed, adjust guide plates if used)
 
*Rocker to valve tip (if needed, adjust guide plates if used)
 
*Rocker slot to stud (if using stamped rockers w/pivot balls)
 
*Rocker slot to stud (if using stamped rockers w/pivot balls)
*Rocker arm/polylok to valve cover or oil baffle
+
*Rocker arm/polylock to valve cover or oil baffle
 
*Camshaft endplay
 
*Camshaft endplay
 
*Distributor shaft endplay and distributor/cam gear mesh/alignment
 
*Distributor shaft endplay and distributor/cam gear mesh/alignment

Latest revision as of 07:29, 15 October 2013

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox