Doug Nash transmission

Jump to: navigation, search

@@ Line 3: / Line 3: @@
 [[File:DOUG NASH 4plus1 RACE TRANS.jpg|thumb|left|350px|Doug Nash 4 plus 1 race tranny]] <br style="clear:both"/>
+You should be able to use a standard big block throw out bearing, the OD of the transmission input shaft bearing retainer should be the same unless it was changed, as it is interchangeable with a Borg Warner T10. To be sure call [http://www.richmondgear.com/01transmissions.html Richmond Transmission support] and/or check the [http://www.richmondgear.com/0002pdfs/TRANSMISSIONMANUAL.pdf manual].
 [[Category:Transmission]]
 [[Category:Undeveloped articles]]
-REPLY:
-You should be able to use a standard big block throw out bearing, the OD of the transmission input shaft bearing retainer should be the same unless it was changed, as it is interchangeable with a Borg & Warner T10's. To be sure call Richmond Transmission support.
-http://www.richmondgear.com/01transmissions.html
-and
-http://www.richmondgear.com/0002pdfs/TRANSMISSIONMANUAL.pdf
-Regards, Jose F. Medeiros :)

Revision as of 00:51, 3 May 2012