Wheel bolt pattern

Jump to: navigation, search
Line 5: Line 5:
 
The PCD can be expressed in mm or inches. The PCD can be found on any 5 lug wheel by measuring from the center of the wheel (the axle hole), to the center of one of the wheel stud holes, and then multiplying that measurement by two. This is difficult on the 5 hole wheel because it is hard to judge the exact center of the large axle hole in the wheel.
 
The PCD can be expressed in mm or inches. The PCD can be found on any 5 lug wheel by measuring from the center of the wheel (the axle hole), to the center of one of the wheel stud holes, and then multiplying that measurement by two. This is difficult on the 5 hole wheel because it is hard to judge the exact center of the large axle hole in the wheel.
  
It may be easier to check this measurement by placing a straight edge (popsicle stick etc.) across the outer edge of two of the wheel stud holes.  Then measure from the center of the wheel hole that is opposite the two holes that the straight edge touches, to the inside (closest) edge of the straight edge.  In other words you are measuring the distance from a straight line touching the outside of two wheel bolt holes, to the center of the opposite wheel bolt hole.  This will be easier to actually measure since you don't have to guess where the center of the large hole in the wheel is, and will closely approximate the diameter of the imaginary circle (PCD)passing through all of the wheel bolt holes.
+
It may be easier to check this measurement by placing a straight edge (popsicle stick etc.) across the outer edge of two of the wheel bolt holes.  Then measure from the center of the wheel hole that is opposite the two holes that the straight edge touches, to the inside (closest) edge of the straight edge.  In other words you are measuring the distance from a straight line touching the outside of two wheel bolt holes, to the center of the opposite wheel bolt hole.  This will be easier to actually measure since you don't have to guess where the center of the large hole in the wheel is, and will closely approximate the diameter of the imaginary circle (PCD)passing through all of the wheel bolt holes.
  
 
On a 4 lug wheel, determine the PCD by measuring across the center of the wheel, from the center of one lug bolt hole to the center of the opposite lug bolt hole.
 
On a 4 lug wheel, determine the PCD by measuring across the center of the wheel, from the center of one lug bolt hole to the center of the opposite lug bolt hole.

Revision as of 17:12, 15 October 2011

Personal tools
Namespaces
Variants
Actions
Navigation
Categories
Toolbox