1940 Ford Pickup recessed tail lights
| Line 23: | Line 23: | ||
Take the bezel and a couple of pieces of masking tape. Locate an appropriate place on the pan (in our case) or flat surface of a fender area and tape the bezel to the surface. | Take the bezel and a couple of pieces of masking tape. Locate an appropriate place on the pan (in our case) or flat surface of a fender area and tape the bezel to the surface. | ||
| + | |||
| + | |||
| + | [[File:4_Layout.JPG]] | ||
| + | |||
| + | [[File:5_tape_down.JPG]] | ||
| + | |||
| + | Scribe a line around the inside of the bezel. | ||
| + | |||
| + | |||
| + | [[File:6_scribe_bezel.JPG]] | ||
| + | |||
| + | [[File:7_scribed_loc.JPG]] | ||
| + | |||
| + | With a lead pencil or fine marker pen draw grid lines around the bezel location to act as a guide and measuring point to measure off of. | ||
| + | |||
| + | [[File:8_Grid_lines.JPG]] | ||
Your Privacy Choices