How to make "speed holes" using dimple dies
(Created page with '== PREAMBLE == Have you ever made a panel or a bracket for your hot rod, only to find out that it was flimsy and flapped in the wind? Here is a way to firm up those flimsy panel…') |
|||
Line 3: | Line 3: | ||
Have you ever made a panel or a bracket for your hot rod, only to find out that it was flimsy and flapped in the wind? Here is a way to firm up those flimsy panels and brackets so that they hold solid and release the air that flows over them. | Have you ever made a panel or a bracket for your hot rod, only to find out that it was flimsy and flapped in the wind? Here is a way to firm up those flimsy panels and brackets so that they hold solid and release the air that flows over them. | ||
− | + | '''How to make 'em''' | |
Start off by drilling a hole or series of holes in the panel or bracket that you want to make using a drill bit that fits the pilot hole of the dimpling die. | Start off by drilling a hole or series of holes in the panel or bracket that you want to make using a drill bit that fits the pilot hole of the dimpling die. |