Editing Phosphoric acid as metal pretreatment
Line 13: | Line 13: | ||
#Because Ospho is water-based, the water can hide in nooks and crannies, causing adhesion failure of primer | #Because Ospho is water-based, the water can hide in nooks and crannies, causing adhesion failure of primer | ||
− | + | ===Technical documents=== | |
− | + | [http://www.skybryte.com/OsphoMSDS.html Ospho MSDS] | |
− | === | + | |
− | + | ||
− | + | ||
====Application tips==== | ====Application tips==== | ||
Line 23: | Line 20: | ||
*Always make sure metal is dry before using ospho or priming. | *Always make sure metal is dry before using ospho or priming. | ||
*Sand or scuff before priming then use a wax and grease remover to clean. | *Sand or scuff before priming then use a wax and grease remover to clean. | ||
− | |||
− | |||
− | |||
==Naval jelly== | ==Naval jelly== | ||
Line 33: | Line 27: | ||
*[http://www.brown.edu/Departments/Visual_Art/documents/NavalJelly.pdf Naval Jelly MSDS] | *[http://www.brown.edu/Departments/Visual_Art/documents/NavalJelly.pdf Naval Jelly MSDS] | ||
*[http://www.permatex.com/documents/tds/Automotive/81756.pdf Naval Jelly Technical Data Sheet] | *[http://www.permatex.com/documents/tds/Automotive/81756.pdf Naval Jelly Technical Data Sheet] | ||
+ | |||
+ | ''need details here on exact concentrations, and use of naval jelly vs. traditional phosphoric acid treatments'' | ||
==Reasons for using phosphoric acid== | ==Reasons for using phosphoric acid== | ||
Line 60: | Line 56: | ||
*[http://www.houseofkolor.com/PDF/TechData/English/KP21.pdf House of Kolor Kwikure Epoxy Primer Surfacer tech sheet]: | *[http://www.houseofkolor.com/PDF/TechData/English/KP21.pdf House of Kolor Kwikure Epoxy Primer Surfacer tech sheet]: | ||
<blockquote> | <blockquote> | ||
− | ''" | + | ''"If you find it necessary to use a metal conditioner to remove rust, etc., be sure to thoroughly clean and nutralize the treated area following the conditioner manufacturers recommendations, then using our KC20 post sanding cleaner with a maroon scuff pad to insure all acid residue has been removed before priming. If not, this will almost certainly cause an adhesion problem."'' |
− | + | ||
− | + | ||
</blockquote> | </blockquote> | ||
Line 77: | Line 71: | ||
==Use of phosphoric acid in an industrial setting== | ==Use of phosphoric acid in an industrial setting== | ||
''this section needs development'' | ''this section needs development'' | ||
− | |||
− | |||
− | |||
− | |||
==References== | ==References== | ||
Line 89: | Line 79: | ||
*http://www.skybryte.com/index.html | *http://www.skybryte.com/index.html | ||
*http://www.ospho.com/data.htm | *http://www.ospho.com/data.htm | ||
− | |||
− | |||
[[Category:Body and exterior]] | [[Category:Body and exterior]] |