Editing How to make "speed holes" using dimple dies
Line 31: | Line 31: | ||
− | If you were making a bracket that required stiffening to make it | + | If you were making a bracket that required stiffening to make it ridged, this is what you would end up with after making a series of holes and using the dimpling dies. A ridged panel that would flow air through it, not hold air back. |
[[File:Pickup_panel.jpg|border|400px]] | [[File:Pickup_panel.jpg|border|400px]] | ||
[[File:Rad_cradle.JPG|border|400px]] | [[File:Rad_cradle.JPG|border|400px]] | ||
[[File:Brackets.JPG]] | [[File:Brackets.JPG]] | ||
+ | |||
===Here's another way to do 'em=== | ===Here's another way to do 'em=== | ||
Line 129: | Line 130: | ||
[[File:REAR_FRAME_STOP.jpg|border|400px]] | [[File:REAR_FRAME_STOP.jpg|border|400px]] | ||
+ | [[Category:General hotrodding]] | ||
[[Category:Body and exterior]] | [[Category:Body and exterior]] |