Editing Vacuum brake bleeder set up (section)
Jump to:
navigation
,
search
===Alternative vacuum source=== This might not be 'recommended' by the auto manufacturers, but engine vacuum has been successfully used instead of a pump. No compressor or pump is required, just the jar and some hoses. If using the engine as a vacuum source, do make sure you are using '''manifold''' vacuum at the sourcing port and not ported vacuum. Make sure to connect directly to intake manifold vacuum (below carburetor or throttle body), do NOT go through any valves,solenoids, etc. that may be damaged if brake fluid enters them (although the jar should prevent that). If you do get brake fluid past the jar and into the engine, a little bit won't hurt, just STAY AWAY from the exhaust pipe! Burning brake fluid STINKS!!! Not recommended for diesels because they have a vacuum pump, normally with a rubber diaphragm. Brake fluid could damage it.
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent