Editing Swapping to rack and pinion steering (section)
Jump to:
navigation
,
search
===Steering "feel"=== If it is simply too “light”, “soft”, or “over responsive”, you may want to address the flow and pressure differentials between RB and R&P. ====Pressure relief valving==== Most older GM pumps will have a pressure rating as high as 1350 psi. The '82–'94 Chevy S10 has the lowest rating at around 1100 psi. The Cavalier rack was designed for a pressure of ~1,000 psi. You can adjust the pressure with a simple shim kit from Borgeson. The pressure relief valve is located behind the high pressure output fitting on the back of the pump. You may need a small magnet to pull it out of the recess. The shim kit comes with a tool to help with removing the end nut, a new O-ring for the outer fitting, and several shims with a guide on how many shims to use to attain the desired pressures. Basically, adding shims reduces the pressure on the spring, allowing the bypass to open sooner and recirculate the fluid, rather than force it to the rack- thus making the pressure lower. The kit allows for reduction to about 750 psi, suitable for a Mustang II rack, which allows you to get well below the normal range for a Cavalier rack. Reduce the sensitivity to what suits you. In most cases, the pressure reduction valve can be removed and replaced with the pump in the car. Yes, you have to drain and refill the pump each time, but that’s pretty minor. ====Flow rate==== The second adjustment available is flow rate. The flow rate is determined by the size of the hole in the high pressure fitting (the one you took out to get to the pressure relief valve) on the back of the pump. The earlier pumps had an output hole of 5/32". The Cavalier pump has an output hole of 1/8" (approximately 20% smaller). I could not find a fitting with the smaller orifice to fit the older pump (newer GM pumps use metric fittings). Perhaps if you start with a later S10 pump, metric might not be an issue- but this needs to be confirmed first. As an alternative, it was fairly simple to weld shut the orifice in the original fitting and re-drill it to 1/8". Note: The experts contend that reducing the pressure will reduce the amount of assist provided, which can be reduced below factory specs to give it a heavier feel. The system is designed with a variable ratio, that is, it is designed to give more assist the further you turn the wheel, like for parking maneuvers, etc. You can't harm it by providing less than factory pressure. The flow rate seems to be more of a factor in the sensitivity over center, where you really don't need any assist. In any event, both changes were noticeable from the original test drive. {| |[[Image:Pump_fitting.jpg|thumb|370px|center|High pressure hose fitting from the back of the power steering pump]] |[[Image:Orifice_hole2.jpg|thumb|310px|center|Weld or braze, then re-drill the center hole to change flow rate, not the side hole]] |} [[Category:Steering]]
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent