Editing Quench (section)
Jump to:
navigation
,
search
==What is squish?== Squish is the name given to the turbulent mixing of the air/fuel mixture caused by the close proximity of the piston to the quench pad(s) of the cylinder head. As the piston approaches top dead center (TDC), the clearance between the crown of the piston and the quench pad of the cylinder head diminishes to about 0.040" (steel rods, aluminum rods require more distance). This squeezes or "squishes" the air/fuel mixture from the area where the piston and head are closest, to the area where the combustion chamber is located. This action creates turbulence to achieve a more homogeneous mixing of the air/fuel mixture. A quench distance of ~0.040" will allow a high performance engine to run without detonation using less octane than would otherwise be needed. Of course this is providing that all the other important areas are also covered, like the static and dynamic compression ratios, correct air/fuel ratio, correct plug heat range, good ring and valve guide seal, etc. <br><br> ;From [http://www.corvetteonline.com/tech-stories/engine/ultimate-guide-to-budget-bbc-cylinder-heads-under-2000/ corvetteonline.com]: <blockquote> While the terms “quench” and “squish” are often used interchangeably by many manufacturers, quench and squish are not the same thing, nor are they produced by the same set of conditions. The [http://www.sae.org/ Society of Automotive Engineers] (SAE) has defined squish as the gases trapped between the piston dome and head that are ejected across the combustion chamber at high speed by the near-collision of the piston dome and head, causing turbulence and mixture homogenization. For our purposes, if the squish area is too close, there is a pumping loss and if the area is too far apart there will be lower squish velocity and less turbulence.<br><br> Quench on the other hand, is the ability to lower temperature of the end gases trapped between the piston dome and head by conduction. This prevents a second flame front from igniting the air/fuel mix prematurely. Members of the SAE acknowledge that for motors with 3.5” to 4.5” cylinder bores, a quench distance of 0.035” to 0.040” work well and result in near zero clearance due to thermal expansion, rod stretch and piston rock-over. </blockquote>
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent